05-21-2021, 09:03 AM
(This post was last modified: 05-21-2021, 09:06 AM byYohan Lemarchandel.)
Hello everyone,
I have a little problem when importing a STEP file as assembly, when importing as assembly there are many frames attached to each items of the STEP file (as shown in picture 1). I would like to know if it's possible to have simple list of object items (as shown in picture 2) when importing a STEP file as assembly?
Thanks
Best regards
I have a little problem when importing a STEP file as assembly, when importing as assembly there are many frames attached to each items of the STEP file (as shown in picture 1). I would like to know if it's possible to have simple list of object items (as shown in picture 2) when importing a STEP file as assembly?
Thanks
Best regards