RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Importing a STEP file as assembly
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Importing a STEP file as assembly

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Importing a STEP file as assembly
Yohan Lemarchandel Offline
Member
**
Posts: 27
Threads: 14
Joined: May 2021
Reputation: 0
#1
05-21-2021, 09:03 AM (This post was last modified: 05-21-2021, 09:06 AM byYohan Lemarchandel.)
Hello everyone,

I have a little problem when importing a STEP file as assembly, when importing as assembly there are many frames attached to each items of the STEP file (as shown in picture 1). I would like to know if it's possible to have simple list of object items (as shown in picture 2) when importing a STEP file as assembly?

Thanks

Best regards

Find
Reply




Users browsing this thread:
1 Guest(s)