Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fusion 360 with RoboDk offset problem

#1
In Fusion 360 CNC simulation works fine. When I send the data to RoboDk the top of my holes are at the fixture surface face and then drill thru the fixture not thru the part. Where do I change to make the top of my fixture the bottom of my part.
#2
Could you share your Fusion 360 project and the RoboDK project?

这些是f3dnd rdk files respectively.
#3
Unable to upload f3d files. Forum software does not allow




Users browsing this thread:
1 Guest(s)