[Bruno Dias]

Hi,
I'm trying to configure the Fanuc RJ3 post-processor to work with a RJ2 controller.
I attached a program generated to RJ2 controler (that run well). The other file was generated with the robodk RJ3 post-processor that i changed, but it dosent work.
The main diferences are that in the Rj2 :ls file appear the following text.

CONTROL_CODE = 00000000 00000000;
/锰
1: UTOOL_NUM[GP1] = 4 ;
2: UFRAME_NUM[GP1] = 1 ;
3:J P[1] 15% FINE ;
4:J P[2] 15% FINE ;

And

UF : 1, UT : 4, CONFIG : 'N, 0, 0, 0',


What happens is that I don't see how to make more changes in the RJ3 .py file to work with my Controller. This .py file i can't post here but i can send to Robodk staff.
Does anyone have some experience with this controller? Or have the Rj2 post-processor already configured?
Thank you
Bruno

[Bruno Dias]

Can someone help?

[massula]

Hi, Bruno.

I don't know if You still need help with this question, but I did some tests here, and noted that RJ3 program has some errors.

First:

Default group must have 5 parameters. Not 7.

Code:

DEFAULT_GROUP = 1,*,*,*,*;

And, at the end of the file, You need to put a new line after the \END statement.

I've uploaded a corrected RJ3 program, You can compare it with the old one.