Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Curve and Linear tool paths. Rhino/Grasshopper

#11
Hello @Albert@Olivier

I tried sending the robot the code and got a python error. Is there a tutorial on how to set up the FTP server? I haven't used that before.

Best, Austen


Attached Files Thumbnail(s)

#12
Hi Austen,

The point in the middle of the line probably comes from your curve in Rhino.

What Denso controller do you have? Most modern robot controllers have a default user name and password you can use to connect via FTP.

Albert
#13
Hello @Albert,

I will see if there are midpoints turned on in rhino. There shouldn't be, but I will double check.

Also,
I have an RC8 controller.

Best,
Austen.
#14
Hello @Oliver @Albert

I have figured out most of my issues with programming and moving and had a few successful prints. I am now trying to program a part that has ~200 curves and I am running into the screen using a "clipping plane" and cutting off parts of my setup. I have my setting set up for best performance under the display. I have a 24 core processor and an RTX 3080 TI graphics card, I should not be limited on my computer side. Do you have any suggestions? I have tried turning off my extruder, table, and robot to see if trying to process would be easier and it hasn't helped.

Best,
Austen


Attached Files Thumbnail(s)


.rdk Denso Station Slip joint test.rdk(Size: 17.93 MB / Downloads: 187)




Users browsing this thread:
1 Guest(s)