[Adegrenier1]

Hello @Albert@Olivier

I tried sending the robot the code and got a python error. Is there a tutorial on how to set up the FTP server? I haven't used that before.

Best, Austen

[Albert]

Hi Austen,

The point in the middle of the line probably comes from your curve in Rhino.

What Denso controller do you have? Most modern robot controllers have a default user name and password you can use to connect via FTP.

Albert

[Adegrenier1]

Hello @Albert,

I will see if there are midpoints turned on in rhino. There shouldn't be, but I will double check.

Also,
I have an RC8 controller.

Best,
Austen.

[Adegrenier1]

Hello @Oliver @Albert

I have figured out most of my issues with programming and moving and had a few successful prints. I am now trying to program a part that has ~200 curves and I am running into the screen using a "clipping plane" and cutting off parts of my setup. I have my setting set up for best performance under the display. I have a 24 core processor and an RTX 3080 TI graphics card, I should not be limited on my computer side. Do you have any suggestions? I have tried turning off my extruder, table, and robot to see if trying to process would be easier and it hasn't helped.

Best,
Austen