05-18-2018, 04:16 PM
Hi,
I am trying to link via ethernet my Dell XPS 15 to my KRC4 controller, smartPAD, and kr30-3.
I have been through the Connect-KUKA-robots-with-RoboDK.pdf setup instructions , gotten a 'succesful' ping message from the RoboDK UI with the robot IP but cannot connect.
Moving on to the troubleshooting section...
Here is the output when I ping the robot from a shell:
I have set my IP address to 172.31.1.142, which only has the last digit different from the robot, so should be on the same network
Where I am currently stuck is with testing the robot driver. After being prompted to install numerous .dll filles, as well as vcredist...exe, I still get two errors when opening either apikuka.exe or apirobot.exe in C:\RoboDK\api\Robot.
I have attached relevant screenshots.
Any help would be great!
Ash
I am trying to link via ethernet my Dell XPS 15 to my KRC4 controller, smartPAD, and kr30-3.
I have been through the Connect-KUKA-robots-with-RoboDK.pdf setup instructions , gotten a 'succesful' ping message from the RoboDK UI with the robot IP but cannot connect.
Moving on to the troubleshooting section...
Here is the output when I ping the robot from a shell:
Code:
发出砰的172.31.1.147与32 bytes of data:
Reply from 172.31.1.142: Destination host unreachable.
Reply from 172.31.1.142: Destination host unreachable.
Reply from 172.31.1.142: Destination host unreachable.
Reply from 172.31.1.142: Destination host unreachable.
Ping statistics for 172.31.1.147:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
I have set my IP address to 172.31.1.142, which only has the last digit different from the robot, so should be on the same network
Where I am currently stuck is with testing the robot driver. After being prompted to install numerous .dll filles, as well as vcredist...exe, I still get two errors when opening either apikuka.exe or apirobot.exe in C:\RoboDK\api\Robot.
I have attached relevant screenshots.
Any help would be great!
Ash